miTEC password lock point set / how to change password

【Password Lock Tutorial】Change Master Password / Change Public Access Code / Add User Access Card for the First Time / Add User Access Card for the Next Time / Cancel Individual User Access Card / Cancel All User Access Cards / Restore Factory Settings  (MKP-3520 / MKP-3500 / MKP-6510 / MKP-6221)

MKP-3520 digital keypad has a wide range of applications for offices, commercial organizations, residential buildings, etc. In addition to the numeric keypad, it is also equipped with a card reader sensor and door clock. MKP-3520 adopts the company's R & D integrated circuit system and new storage chip, up to 600 users can be registered, and the data inside the machine will not be lost due to power failure.MKP-3520 digital keypad is especially equipped with door status monitoring, alarm output, AUX password, etc., IP65 waterproof, dustproof design, can be used for outdoor installation.

The following is a guide to the 7 basic functions of the MKP-3520 combination lock, which is convenient for new installers to complete the simple startup setup. In addition, for security reasons, it is recommended that the Master Password and Common Access Code should be changed regularly. If you forget the Master Password or suspect that the device's Master Password has been compromised, please operate the device back to the original factory settings and reset the Master Password immediately.

Click here https://youtu.be/dqFJ2soD1do to watch demonstration。

Change Master Password

Factory Default Master Password：1234

1. Enter the factory master password twice to enter the "Setup" mode.
2. Press * 000
3. Input the new master password
4. Press # to finish setup

Change Public Password

1. Enter the master password twice to enter the "Setup" mode.
2. Press * 601
3. Input the new public password
4. Press # to finish setup

First time adding a user door opener card

1. Enter the master password twice to enter the "Setup" mode.
2. Press * 001
3. From user code 001，tap the user cards on the keypad in order
4. Press # to finish setup

Note: Before operating the password keypad, it is recommended to mark each user card with a three-digit user number in sequence from 001-600 (up to 600 additional users)

Addition of user access cards in the future

1. Enter the master password twice to enter the "Setup" mode.
2. Press * 
3. Input the new card user code（Three digits card code：e.g. 005）
4. Press # to finish setup

Note: Subsequent card numbers should not overlap with the registered card number, otherwise the old card will be invalidated.

Cancel Individual User Access Cards

1. Enter the master password twice to enter the "Setup" mode.
2. Press * 850
3. Press 1
4. Input the card user code to be cacelled（Three digits card code：e.g. 005）
5. Press # to finish setup

Cancel All User Access Cards

1. Enter the master password twice to enter the "Setup" mode.
2. Press * 850
3. Press 1 000
4. Enter the master password
5. Press # to finish setup

Restore Factory Settings

1. Unscrew the screws on the underside of the unit to open the bottom cover.
2. Unlink the upper left red & black lines from the base plate.
3. Place the lower right jumper over the second and third jumpers.
4. Repin the red & black wires to the power supply.
5. A long beep will sound when the power is connected. Place the lower right jumper back on the first and second jumpers.
6. Close the bottom cover